1. Remove the keys from the device
If the device is moved to new location for other usage, you might need take the keys out from the device.
You can take the keys out by opening the lockers from the webpage.
First-Generation Dashboard:
Click "Open locker" -button from "Keys" -view
Next-Generation Dashboard:
Right click the key from "Key automats" -view and select "Open locker".
2. Take the device off from the wall bracket
Open the lock located in the right-side in the bottom of the device with the key which was delivered together with the device.
 | 
|
Lift the device carefully and take it out from the wall bracket. Pay attention to the power cable so that it will not be damaged.
Power off the device by power switch. The power switch is located on the circuit board and you can reach it from the back side of the device.
3. Unmount the wall bracket from the wall
Take the wall bracket from the wall by removing the screws.
The wall bracket is often mounted with 6 screws.
4. Install the wall bracket and device to new location
Install the wall bracket and device to new location according to following instructions:
5. Rename the device / change the address
If needed, you can rename the device or change its address.
First-Generation Dashboard:
The device can be renamed from the "Settings" -view:
Next-Generation Dashboard:
The address of the device can be changed from device's "Settings" -view:
